HP Integrity NonStop J-Series - Manual (Page 197)

that a power failure exceeds the powerfail-delay time interval specified for your UPS. For more
information on preparing for AC power-fail scenarios, see the Planning Guide for your NonStop
system. For more information on using the POWERFAIL_DELAY_TIME command to specify the
Power-Failure-to-Shutdown time interval, see the SCF Reference Manual for the Kernel Subsystem.
NOTE: This action is not valid for a power supply unit in an S-series VIO Module.
Delete the Power Source Configuration
Sets the Configuration > Power Supply attribute value to Not Configured. You must be logged on
as super.super to perform this action.
NOTE: This action is not valid for a power supply unit in an S-series VIO Module.
Replace
Displays a service procedure describing how to replace a power supply in a VIO enclosure.
Processor (CLIM)
A subcomponent of the CLIM .
Location in OSM Tree: System > CLIMs > CLIM > Processor
Attributes
Processor
Displayed in the Attributes tab and Attributes dialog box only if the value is
something other than OK.
Values
Service State
Physical
Identifies the manufacturer of the component. Manufacturer
The model number of the CLIM processor that was assigned in manufacturing. Model
Logical
The processor speed. Current Speed
The state of the CLIM processor as known to the operating system on the
server. Possible values include: OK, Degraded, Fault, Off Duty. Device State
Actions
Replace
Launches a documented service procedure to replace a processor in a CLIM.
Processor Blade
This object represents one of the eight processor blades in an Integrity NonStop blade server.
There can be one or two Integrity NonStop blade servers in an Integrity NonStop BladeSystem. In
the OSM Service Connection, the Processor Blade objects are found within the
Enclosure object,
which represents each blade server.
Within each Processor Blade object, OSM displays eight Memory Cards and a ServerNet Interface
Card .
Processor (CLIM) 197