Data collection services, System load configuration, Incident report configuration – HP Integrity NonStop J-Series User Manual
Page 233: Actions, Add node to servernet cluster, Bring up and balance storage paths, Check dhcp and dns server status
Data Collection Services
Indicates whether automatic data collection for failed system resources is
enabled or disabled. To change this attribute state, use the
action.
Automatic Data Collection State
Indicates the volume in which automatic or manual data collection will take
place. This volume is assigned by using the
action.
Diagnostic Data Collection Volume
Indicates the number of days that collected hardware failure data (collected
either automatically or by the
action) is retained on
the system before being deleted.
Days to Persist Collected Diagnostic Data
System Load Configuration
Displays the name of an alternate system load configuration, as specified
through the Save As System Load Configuration action (located under the
, and
objects in the OSM Service
Connection). You can specify up to four such alternate system disks; each
one is displayed in the system attributes (under a separate System Load
Configuration heading), and can be selected from the Configuration menu
of the System Load dialog box in the OSM Low-Level Link.
These configurations can be deleted by the system-level
action.
NOTE:
With OSM Low-Level Link T0633 AAQ and later, you can also save
system configuration files on the system console. Those saved configurations
are not displayed as attributes values in the OSM Service Connection, but
can be used during the system load operations in the Low-Level Link. For
more information, see the OSM Low-Level Link online help.
Configuration Name
The name of this alternate system disk, as configured in SCF.
Disk Name
Incident Report Configuration
Indicates whether or not OSM's ability to create Problem Incident Reports
has been suppressed. This suppression is accomplished by the
Problem Incident Report Creation
action and is desirable to stop dial-out of
known problems, such as those that may occur during CRU replacements.
Values: Suppressed, Unsuppressed
Problem Incident Report Creation State
Actions
Add Node to ServerNet Cluster
Launches a guided procedure that adds the local system to a ServerNet Cluster or
.
This procedure is also used to configure or display information for Expand-over-ServerNet line
handlers.
NOTE:
This action is not applicable for Integrity NonStop NS1000, NS1200, NS2000 series,
NS2100, NS2200 series, NS2300, NS2400 series, NS5000, or NS3000AC servers.
Bring Up and Balance Storage Paths
Launches a guided procedure to help recover from ServerNet disruption to storage paths.
Check DHCP and DNS Server Status
Invokes checks to determine whether DHCP, DNS, and TFTPD servers are running.
System 233