HP Integrity NonStop J-Series - Manual (Page 227)

Logical
The state of the component as known to the operating system on the server.
Values
Device State
Physical
The Physical attributes are displayed for SWAN 2 CLIPs only.
The part number of the component that was assigned in manufacturing. Use
part numbers for identifying and ordering parts. Part Number
A unique serial number that identifies the component. Track IDs are used for
tracking components. Track ID
A code that identifies the generation of the component. Hardware revision
codes are used for tracking components. Hardware Revision
Firmware
The version of the firmware on the concentrator communications line interface
processor (CLIP) of the ServerNet wide area network (SWAN). Version
The name of the file to be used for a firmware update. Default File Name
The version of the firmware to be used for a firmware update . Default File Version
The differences, if any, between the current and default firmware versions.
Values
Compare State
Actions
Firmware Update
Updates the firmware on the ServerNet wide area network (SWAN) concentrator communications
line interface processor (CLIP).
Optional Parameter: File Name of the firmware file.
There is no SWAN Fast Firmware Update guided procedure in OSM because you can use the
Multi-Resource Actions to stop, update, and restart any or all SWAN CLIPs on your system
simultaneously.
Start
Starts the SWAN CLIP. When the Start action completes, the SWAN CLIP is in the Started state.
In a multisystem configuration, this action also causes the current system to take control of the CLIP.
If the CLIP is currently controlled by another system, that system loses control of the CLIP.
Stop
Terminates operation of the SWAN CLIP. When the Stop action completes, the SWAN CLIP is in
the Stopped state.
Test Backup Path Access
Tests two-way access to the communications line interface processor (CLIP) using the alternate
address.
SWAN CLIP 227