HP Integrity NonStop J-Series - Manual (Page 218)

Logical
The maximum processor configuration for the service processor. Values Current Topology
The state of the service processor:
Active (Primary): This is the active SP and it is available.
Active (Secondary): This is not the active SP, but it is available.
Firmware Update Mode: An SP firmware update is in progress.
In Test: Temporary state during power-on self-test.
Initializing: Temporary state during startup.
SP Stopped Responding to Peer:
Device State
The IPv4 address of the service processor. IPv4 Address
Indicates whether this service processor is the master service processor on
the system:
Indicates whether this service processor is the master service processor on
the system. The value will always be False on a legacy IOMF2 SP in an
Integrity NonStop NS-series server. Master SP
Indicates whether the SP firmware was loaded from its own (local), the peer's,
or the backup flash memory. Running Image Source
The maximum processor configuration for the service processor that is set
the next time the system or enclosure is powered on.
Values
Stored Topology
The date and time that the service processor was last reset. Time of Last Reset
This attribute is displayed only within the Multi-Resource Actions dialog box,
to indicate whether the SP is on the X or Y ServerNet fabric. Fabric Side
SP Firmware
The VPROC of the firmware currently loaded on the service processor. Version
The name of the file to be used for the service processor firmware update.
(SPCODE9) Default File Name
The version of the firmware to be used for a firmware update . Default File Version
The differences, if any, between the current and default firmware versions.
Values
Compare State
SCSI Boot Code Firmware
These attributes are displayed only for SPs located in PMF or PMF2 CRUs; not for those in IOMF
or IOMF2 CRUs.
The version of the firmware running on the SCSI controller on the PMF CRU
that contains the service processor. Version
The name of the file to be used for the SCSI Boot Code firmware update. Default File Name
The version of the firmware to be used for the SCSI Boot Code firmware
update. Default File Version
The differences, if any, between the current and default firmware versions.
Values
Compare State
218 System Resources