Synchronize fir files to other switches, Write lcd line, Common attribute values – HP Integrity NonStop J-Series User Manual
Page 253: Battery charge status

With T0682 H02 AAN and later, you can also use the
to set the Rack
Name and Rack Offset values in a consistent manner throughout the system while you create a
physical view of your modular racks.
Synchronize FIR Files to Other Switches
Synchronizes the FRU information record (FIR) files of the X and Y fabric processor switches.
NOTE:
This action is only valid from Group 100; it will fail on VIO Modules in NonStop
BladeSystem NB54000c and NB56000c or S-series.
Write LCD Line
Allows you to edit the text displayed by the VIO enclosure’s LCD. You can modify lines 9 through
15 with this action.
Common Attribute Values
Battery Charge Status
Meaning
Value
The battery is not installed.
Absent
The battery is fully charged
Charged
The battery is in the process of being charged.
Charging
The battery cannot supply power and cannot be charged, possibly because the Disable Battery
action has been performed. You should disable a battery before removal.
Disabled
The battery needs recharging or replacement.
Discharged
The system is currently drawing power from the battery.
Discharging
The battery can accept a charge and is ready to supply power if the AC power is unavailable.
Enabled
Check the battery for alarms. If the condition persists, contact your service provider.
Fault
The battery is not responding, and its state cannot be determined.
Unknown
Compare State (CLIM, SAS Disk Enclosure, CLIM SAS Card, and CLIM FC Card)
Meaning
Value
Current and default versions are the same.
Same
Available on H06.20/J06.09 and later SUTs, the current version is either newer or older than
the default version, but is compatible with the default version.
Compatible
The current version is newer than the default version.
OSM version T0682 H02 ACJ (and later) supports the option of flagging Up-rev firmware on
CLIM and SAS Disk Enclosure components as a problem attribute that is propagated up to
parent objects in the OSM Service Connection. For information on how configure this option
in your OSMCONF file, see the OSM Configuration Guide.
Up-rev
The current version is older than the default version.
Down-rev
Unable to compare files.
Unknown
Common Attribute Values 253