Exiting the editor – Rockwell Automation 9323-S5500D A.I. SERIES MICROLOGIX 1000 AND PLC-500 SOFTW User Manual
Page 63

Configuring the SLC 500 CPU and I/O Modules
3-7
To delete a card from the configuration, highlight the card and select
[F6]
Delete
. You
can place the last line you deleted at the highlighted location by pressing
[F7]
Undel
.
If this location already has a card assigned to it, the previously deleted card will replace
the current one.
[F8]
spioCfg
brings up the advanced I/O configuration window for the highlighted
card. This only applies to SLC 5/02 processors and higher using certain specialty I/O
cards.
Note
The following applies to the Configuration Screen (existing projects) as the
[F9]
Monitor
key is unavailable on the Definition Screen:
You can also enter descriptions or device assignments for I/O points on discrete
modules. To enter these descriptions:
1.
Highlight the card. Press
[F9]
Monitor
to display the I/O points on the card.
2.
You can attach device descriptions to the I/O points. Press
[F7]
deVice
to enter a
device. Press
[F9]
desCrib
to enter description text only.
3.
You can press
[F8]
disMode
to toggle display modes for device or description text.
4.
To return to the module list, press
[Esc]
.
Exiting the Editor
Press
[Esc]
to back out through the menu structure. When you exit the top menu of the
editor after changing the configuration or the ladder logic, PLC-500 A.I. will inform
you that the program and/or data has changed. A dialog box asks you whether you
want to save the changes. Press
[F1]
Yes
to save the changes. A screen similar to the
one below appears. The options you are given depend on the type of processor.