Rockwell Automation 9323-S5500D A.I. SERIES MICROLOGIX 1000 AND PLC-500 SOFTW - Manual (Page 348)

MicroLogix 1000 and PLC-500 A.I. Series Software Reference
15-12
1784-KL Interface Card
PLC-500 A.I. automatically configures the KL card’s memory address when you select
the KL as your communication device.
The table below describes the parameters that become available when you select this
device.
Note You need Rockwell Software’s S5-103 cable to use a 1784-KL card on a DH-485
network.
Communication Medium
Parameter DH-485 (w/RSI S5-103) DH+ / DH-485 Bridged DH+
[F1] Computer/
Terminal
Address
enter the station
address(0-31 decimal).
This address must be
unique on the network. enter the station address
(0-77 octal). This
address must be unique
on the network. enter the station address (0-77
octal). This address must be
unique on the network.
[F5] Baud rate select the baud rate of
the DH-485 network not available not available
[F7] 1785-KA5
DH+ Address
not available enter the DH+ station
address of the 1785-KA5 not available
[F8] Terminal
Name
not available enter an 8-character
name that will be
displayed when a DH+
Who Active is run enter an 8-character name that
will be displayed when a DH+
Who Active is run
[F9] DH+ Link
ID
not available enter the DH+ channel
link ID of the 1785-KA5 not available
[F9] LOCAL not available not available displays the Configure Local
Remote Settings menu. From
this menu, press
[F1] Network
Mode to toggle between LOCAL,
REMOTE, or DH+ ROUTING.
Refer to
DH+ Direct
Local/Remote Settings on page
15-29 .
For information on excluding memory addresses to avoid conflicts with the interface
card, refer to the Hardware Interface Configuration Guide .