Rockwell Automation 9323-S5500D A.I. SERIES MICROLOGIX 1000 AND PLC-500 SOFTW User Manual
Page 255
Creating and Printing Reports
11-19
[F3]
Ladder Xref Print Mode
Toggle between
Normal
and
Compressed
.
Normal mode format:
T4:1 - TON - File #2 MAIN_PGM2 - 11
File #29 - 8
T4:1.DN - -| |- - Fle #5 SCALE_OPER - 28, 39
Address
Instruction Type
File Number
Filename
Rung Number
Compressed mode format:
T4:1 - 11, [29] 8 , {DN}, [5] 28, 39
Address
Rung Number
File Number
Subelement
§
Numbers or characters within braces { } are bits or subelements of the address.
The information following the braces applies to that subelement.
§
Numbers within brackets [ ] are file numbers. The information following a set
of brackets refers to that file number.
§
If no ladder file is specified, the data refers to the file being printed. (This is
why, in the example above, file numbers 29 and 5 are specified, but file
number 2 is not.)
§
A “/” character before a number indicates an XIO contact, otherwise the
reference is either an OTE, OTL, OTU or XIC.
§
A “w” or “f” before a rung number indicates use as a word or file, respectively.
This could be in a MOV or TON instruction, for example.
Note
To print a key to the compressed mode symbols, enable the
Table of Contents/Key
report under
Report selections 2
.