Rockwell Automation 9323-S5500D A.I. SERIES MICROLOGIX 1000 AND PLC-500 SOFTW User Manual
Page 385
Channel Configuration
16-7
4.
Select
[F7]
chancFg
. This displays the channel configuration screen. (The screen
shown below is for a SLC 5/04 processor. Fewer options are available with a
SLC 5/03 processor.)
5.
The highlight bar should be on the
Current Communication Mode
field for
Channel 0. If it is not, use the arrow keys to move the highlight bar to that
location.
6.
Press
[F9]
Select
to toggle between System and User Mode. Select User Mode if
you want to use the Generic ASCII driver, otherwise select System Mode.
7.
If you have selected System Mode, highlight the
System Mode Driver
field. Press
[F9]
Select
to toggle between DF1 Full-Duplex, DF1 Half-Duplex Limited Master
(except on SLC 5/03 OS301 processors), DF1 Half-Duplex Slave, DH-485 Master,
and Shutdown (disable).
8.
If you have selected User Mode, highlight the
User Mode Driver
field. Press
[F9]
Select
to toggle between Generic ASCII and Shutdown (disable).
9.
Set remaining options. (Refer to the table on page
16-8
.)
§
Use the arrow keys to highlight the option you want to change.
§
Press
[F9]
Select
to toggle the settings.
10.
Press
[F1]
Accept
to accept the changes.
Command Portal keys
for this function:
.DF