Rockwell Automation 9323-S5500D A.I. SERIES MICROLOGIX 1000 AND PLC-500 SOFTW - Manual (Page 352)

MicroLogix 1000 and PLC-500 A.I. Series Software Reference
15-16
1784-KTX/KTXD Interface Card
The table below describes the parameters that become available when you select this
device.
Communication Medium
Parameter DH-485 DH+ / DH-485 Bridged DH+
[F1] Computer/
Terminal
Address
enter the station address
(0-31 decimal). This
address must be unique
on the network. enter the station address
(0-77 octal). This
address must be unique
on the network. enter the station address (0-77
octal). This address must be
unique on the network.
[F4] KTX
Communica-
tions Board
Addr
Hexadecimal address
must match the KTX
card’s base memory
address.* Hexadecimal address
must match the KTX
card’s base memory
address.* Hexadecimal address must
match the KTX card’s base
memory address.*
[F5] Baud rate select the baud rate of
the DH-485 network not available not available
[F7] 1785-KA5
DH+ Address
not available enter the DH+ station
address of the 1785-KA5 not available
[F8] Terminal
Name
not available enter an 8-character
name that will be
displayed when a DH+
Who Active is run enter an 8-character name that
will be displayed when a DH+
Who Active is run
[F9] DH+ Link
ID
not available enter the DH+ channel
link ID of the 1785-KA5 not available
[F9] LOCAL not available not available displays the Configure Local
Remote Settings menu. From
this menu, press
[F1] Network
Mode to toggle between LOCAL,
REMOTE, or DH+ ROUTING.
Refer to
DH+ Direct
Local/Remote Settings on page
15-29 .
*For information on excluding memory addresses to avoid conflicts with the interface
card, refer to the Hardware Interface Configuration Guide .