Rockwell Automation 9323-S5500D A.I. SERIES MICROLOGIX 1000 AND PLC-500 SOFTW User Manual
Page 190

MicroLogix 1000 and PLC-500 A.I. Series Software Reference
8-20
To…
Press…
move cursor to start of previous word
[Ctrl-
Я
Я
]
move cursor to start of next word
[Ctrl-
а
а
]
move cursor to start of current line
[Home]
move cursor to the top of the file
[Home] [Home]
move cursor to end of current line
[End]
move cursor to the end of the file
[End] [End]
move one page up or down
[PgUp] or [PgDn]
move to the top of the file or the end of the file
[Ctrl-PgUp] or
[Ctrl-PgDn]
After you use
[F1]
or
[F9]
to read or write a block of text to a file, the software will
prompt you for a filename. You can press
[Enter]
to use the file selector to chose a
directory and filename or you can type the drive\path\filename.
4.
Press
[Esc]
to exit the Note Editor. PLC-500 A.I. will ask if you want to save the
changes. Select
[F1]
to save the changes.
The note text is stored in a plain ASCII text file titled NOTES.TXT (unless you have
configured another name using the Editor Configuration window, described in the
Configuring the Rung Editor
section on page
8-10
), and is not connected with any
particular component of the ladder program.
Command Portal keys
for this function:
.TC