Rockwell Automation 9323-S5500D A.I. SERIES MICROLOGIX 1000 AND PLC-500 SOFTW - Manual (Page 251)

Creating and Printing Reports
11-15
[F4] Box Rung Description
Use this option to enclose rung description text in a box composed of any valid
IBM character. Enabling this option displays a menu to select one of seven
predefined characters or to enter a custom character. To enter custom characters
press [F8] , then the key for that character. To enter non-keyboard characters, hold
down the [Alt] key and enter the ASCII code number on the numeric keypad. IBM
graphics characters will print only if
§
your printer supports these characters,
§ your printer’s support for these characters is enabled, and
§ your selected printer driver has [F3] Use IBM Graphics set to Yes . See
Create a New Printer Driver on page 11-40 for details.
[F5] Chk Page on Vert Split
When rungs are too wide to fit between the left and right power rails, the rungs
split vertically and continue below and slightly to the right of the left power rail.
Enabling this option keeps split portions of a rung on the same page.
[F7] # of Des Lines to print
Toggle between 0 , 1 , 2 , 3 , 4 , and 5 to set the number of description lines to print
above instructions.
Note: To print all the instruction descriptions above multiple address instructions,
see “Enhanced” under the [F2] Ladder Print Mode option on the previous page.
[F8] Symbolic Mode
The different modes are Normal , Replace , or None . Normal causes both the
address and symbol to print. Replace causes only the symbol name to print, if it
exists; otherwise the address will print. None prints addresses only.
[F9] Show I/O Cards
With this option enabled, real input and output addresses display the I/O card
mnemonic (e.g., OA8, IA8, etc.) below the instruction.