Channel 0’s default settings – Rockwell Automation 9323-S5500D A.I. SERIES MICROLOGIX 1000 AND PLC-500 SOFTW User Manual
Page 382

MicroLogix 1000 and PLC-500 A.I. Series Software Reference
16-4
Channel 0’s Default Settings
Channel 0’s default settings are important if you want to go online with the processor
using Channel 0. You can change these settings once you are online (see
Configuring
Channel 0
on page
16-6
).
By default, Channel 0 is set for DF1 Full Duplex. This means that you can go online
with the 5/03 or 5/04 through Channel 0 without having to preconfigure the port. The
default settings for the channel are as shown on the following screen display.
When you are attempting to get online with a new SLC 5/03 or 5/04 processor through
Channel 0, use the same baud rate, parity, duplex, and error detection mode settings in
your communications configuration in PLC-500 A.I. If that fails, use the Find Baud,
Parity, Protocol Settings function described in
Chapter 15 - Configuration for Online
Communications
.