Rockwell Automation 9323-S5500D A.I. SERIES MICROLOGIX 1000 AND PLC-500 SOFTW - Manual (Page 423)

Online Editing and Monitoring
18-13
3. Select [F1] Yes to test the edits. The Edits field on the status line changes from
Dis to Tst .
§ If you are in a program mode online editing session, a compile is performed on
all unmarked rungs and rungs marked with insert zone markers.
§ If you are in a run mode online editing session, the processor executes normal
rungs and all rungs marked with insert zones. Rungs marked with delete or
replace zones are not executed.
4. When testing edits, the menu bar will change to provide Untest and Assemble
options as shown on the screen below.
Notice that editing options are not available while testing edits. If you need to
make corrections to the program, select [F8] Untest . If you are confident that the
program runs as expected, you can press [F9] Assem to assemble the edits. These
options are explained in detail below.