CANOGA PERKINS 9175 Command Reference - Manual (Page 95)

CanogaOS Command Reference
6-5
6.8 show interface switchport
Use this command to show the vlan configurations on all bridge ports or a bridge port.
Command Syntax
show interface switchport {interface IFNAME|}
Command Mode
EXEC
Usage
None
Examples
This example shows how to display the vlan configurations on all bridge ports or a bridge port:
Switch# show interface switchport interface eth-0-1
Related Commands
switchport mode access
switchport mode trunk
6.9 vlan classifier activate
Use this command to apply vlan classifier group to an interface.
To remove it, use the no form of this command.
Command Syntax
vlan classifier activate group-id based {ip|mac|protocol}
no vlan classifier activate
group-id: <0-31> VLAN classifier group id
{ip|mac|protocol}: based on ip or mac or protocol
Command Mode
Interface configuration
Usage
An interface can only be applied by one vlan classifier group.
One vlan classifier group can apply more than one interface.
This command apply vlan classifier group to interface, and the interface can classify packets to different
vlan according to the rule in vlan classifier group.
To create the rule, reference to vlan classifier rule command.
To create the group, reference to vlan classifier group command.
Examples