CANOGA PERKINS 9175 Command Reference - Manual (Page 506)

CanogaOS Command Reference
28-18
match command specifies the match criteria under which redistribution is allowed for the
current route-map. The set command specifies the set redistribution actions to be performed, if
the match criteria are met.
If the packets do not match any of the defined criteria, they are routed through the normal
routing process.
Note:
This command is valid for BGP only.
Command Syntax
set community [ AA:NN | internet | local-AS | no-advertise | no-export ] [additive]
set community none
no set community
Syntax Description
AA:NN Specifies the community number in this format.
AA = The AS number.
NN = The number assigned to community.
internet Specifies the Internet (well-known community).
local-AS Specifies no sending outside the local AS
(well-known community).
no-advertise Specifies no advertisement of this route to any peer
(well-known community).
no-export Specifies no advertisement of this route to next AS
(well-known community).
none Removes the community attribute from the prefixes
that pass the route-map.
additive Adds to the existing community.
Command Mode
Route-map mode
Defaults
No set community is specified by default.
Examples
The following examples show the use of the set community command with different
parameters.
Switch# configure terminal
Switch(config)# route-map rmap1 permit 3
Switch(config-route-map)# set community no-export no-advertise
Switch# configure terminal
Switch(config)# route-map rmap1 permit 3
Switch(config-route-map)# set community no-advertise