CANOGA PERKINS 9175 Command Reference - Manual (Page 478)

CanogaOS Command Reference
27-2
Command Syntax
address-family vpnv4 unicast
unicast Address Family modifier
Default
Disabled
Command Mode
Router mode
Usage
Use this command to enter the address family configuration mode. The address family mode allows the
configuration of routing sessions that use VPN version 4 address prefixes. Use the exit-address-family
command to go back to router mode.
Examples
In the following example note that the prompt changed to config-router-af after using the address-family
command.
Switch# configure terminal
Switch(config)# router bgp 100
Switch(config-router)# address-family vpnv4 unicast
Related Commands
address-family ipv4 vrf, exit-address-family, neighbor active
27.3 debug bgp mpls
Use this command to enable the display of MPLS related information.
Use the no parameter with this command to disable this function.
Note: This command is available only when vrf option is enabled.
Command Syntax
(no) debug bgp mpls
Default
Disabled
Command Mode
Privileged Exec mode
Examples
debug bgp mpls