CANOGA PERKINS 9175 Command Reference - Manual (Page 91)

CanogaOS Command Reference
6-1
6 VLAN Commands
6.1 vlan database
Use this command to enter vlan configure mode
Command Syntax
vlan database
Command Mode
Global configuration
Usage
When you try to create or remove vlan, you must use this command to enter vlan configure mode first.
To exit vlan configure mode, use exit command.
Examples
This example shows how to enter vlan configure mode:
Switch(config)# vlan database
Switch(config-vlan)#
This example shows how to exit vlan configure mode:
Switch(config-vlan)# exit
Switch(config)#
Related Commands
exit
6.2 vlan <1-4094> replace dscp
Use this command to enable dscp on specific vlan.
To disable it, use the no form of this command.
Command Syntax
vlan vlan replace dscp
no vlan vlan replace dscp
vlan: <1-4094> vlan id
Command Mode
VLAN configuration
Usage
None
Examples