CANOGA PERKINS 9175 Command Reference - Manual (Page 539)

CanogaOS Command Reference
30-8
MPLS echo reply, sender address of the
packet, and return codes.
dsmap Indicates that a downstream mapping
(DSMAP) type length and value should be
included in the LSP echo request.
flags Received LSR must do an FEC stack
validation. Optional. Default is disabled.
interval
INT_VAL Specifies a send interval between requests (in
milliseconds). The range is from 2 to
20000.Default is 2.
repeat
REP_VAL Specifies the number of times to resend a
packet. The range is from 1 to 5000. Default is
5.
reply-mode
MODE Specifies the reply mode for the echo request
packet.
z Reply with IP UDP packet (default)
z Reply with IP UDP packet with router alert
timeout
TIME_OUT Specifies the timeout interval in seconds. The
range is from 1 to 500. Default is 60.
ttl TTL_VAL Specifies the TTL value to be used in the
MPLS labels.
The range is from 1 to 255. Default is 255.
Command Mode
Privileged Exec mode
Defaults
This command has no default settings.
Examples
In the following example, the traceroute mpls l3vpn command is used to
initiate tracing the route traversed by the specified VPN instance echo request
packet in the MPLS cloud.
Switch# traceroute mpls l3vpn vpn1 1.1.1.0/24 source 10.10.10.10 destination
127.0.0.1 dsmap detail flags interval 100 repeat 100 reply-mode timeout 100 ttl
200
Related Commands
ping mpls l3vpn