CANOGA PERKINS 9175 Command Reference - Manual (Page 103)

CanogaOS Command Reference
6-13
6.21 switchport trunk native
Use this command to set the native vlan for sending and receiving untagged traffic.
To return the native vlan to default value, use the no form of this command.
Command Syntax
switchport trunk native vlan vlan
no switchport trunk native vlan
vlan: <2-4094> an existing vlan id
Command Mode
Interface configuration
Defaults
1
Usage
None
Examples
This example shows how to set the native vlan to vlan 10 on the interface.
Switch(config-if)#switchport trunk native vlan 10
This example shows how to return the native vlan to default on the interface.
Switch(config-if)#no switchport trunk native vlan
Related Commands
switchport trunk allowed