CANOGA PERKINS 9175 Command Reference - Manual (Page 489)

CanogaOS Command Reference
28-1
28 Route-map Commands
28.1 route-map
To define the conditions for redistributing routes from one routing protocol into
another, or to enable policy routing in bgp, use the route-map command in
global configuration mode and the match and set command in route-map
configuration modes. To delete an entry, use the no form of this command.
Command Syntax
route-map map-tag [permit | deny] [sequence-number]
no route-map map-tag [permit | deny] [sequence-number]
Syntax Description
map-tag A meaningful name for the route map. The
redistribute router configuration command uses this
name to reference this route map. Multiple route maps
may share the same map tag name. The length of
route-map name should not greater than 20 and t he first
character should be 'a'-'z', 'A'-'Z' or '0'-'9'.
permit (Optional) If the match criteria are met for this route
map, and the permit keyword is specified, the route is
redistributed as controlled by the set actions.
If the match criteria are not met, and the permit
keyword is specified, the next route map with the same
map tag is tested. If a route passes none of the match
criteria for the set of route maps sharing the same name, it
is not redistributed by that set.
deny (Optional) If the match criteria are met for the route
map and the deny keyword is specified, the route is not
redistributed.
sequence-number (Optional) Number that indicates the position a new
route map will have in the list of route maps already
configured with the same name. If given with the no form
of this command, the position of the route map should be
deleted.
Command Mode
Global configuration
Defaults
The permit keyword is the default.