CANOGA PERKINS 9175 Command Reference - Manual (Page 349)

CanogaOS Command Reference
19-18
the match criteria are met.
If the packets do not match any of the defined criteria, they are routed through the normal
routing process.
Note:
This command is valid for BGP only.
Command Syntax
set community [ AA:NN | internet | local-AS | no-advertise | no-export ] [additive]
set community none
no set community
Syntax Description
AA:NN Specifies the community number in this format.
AA = The AS number.
NN = The number assigned to community.
internet Specifies the Internet (well-known community).
local-AS Specifies no sending outside the local AS
(well-known community).
no-advertise Specifies no advertisement of this route to any peer
(well-known community).
no-export Specifies no advertisement of this route to next AS
(well-known community).
none Removes the community attribute from the prefixes
that pass the route-map.
additive Adds to the existing community.
Command Mode
Route-map mode
Defaults
No set community is specified by default.
Examples
The following examples show the use of the set community command with different
parameters.
Switch# configure terminal
Switch(config)# route-map rmap1 permit 3
Switch(config-route-map)# set community no-export no-advertise
Switch# configure terminal
Switch(config)# route-map rmap1 permit 3
Switch(config-route-map)# set community no-advertise
Switch# configure terminal
Switch(config)# route-map rmap1 permit 3