CANOGA PERKINS 9175 Command Reference - Manual (Page 140)

CanogaOS Command Reference
8-4
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)#erps 11 ring 1 level sub
And you can check the result by using “show erps 11” command.
Switch# show erps 11
ERPS domain ID: 11
ERPS domain name: test11
ERPS domain primary control VLAN ID: 16
ERPS domain sub control VLAN ID: 15
ERPS domain hello timer interval: 1 second(s)
ERPS domain fail timer interval: 5 second(s)
ERPS ring ID: 1
ERPS ring level: sub
ERPS ring 1 node mode: unknown
ERPS ring 1 node state: idle
ERPS ring 1 primary interface name: not configured
ERPS ring 1 secondary interface name: not configured
Related Commands
None
8.5 erps ring mode
Use this command to set/unset specific ERPS ring instance node mode.
Command Syntax
erps ERPS_ID ring RING_ID mode {master | transit}
no erps ERPS_ID ring RING_ID mode
ERPS_ID : <1-255> ERPS domain ID
RING_ID : <1-255> ERPS ring ID
master: master node
transit: transit node
Command Mode
Global configuration
Usage
None
Examples
This example shows how to set node as ERPS domain 11 ring 1 transit node.
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# erps 11 ring 1 mode transit