CANOGA PERKINS 9175 Command Reference - Manual (Page 111)

CanogaOS Command Reference
7-8
Switch(config)# spanning-tree bpdu-transparent enable
Related Commands
7.12 spanning-tree port
Use this command to set the port enable or disable spanning tree protocol. The default state is enabled.
Command Syntax
spanning-tree port {enable | disable}
enable Enable spanning protocol on this port.
disable Disable spanning protocol on this port.
Command Mode
Interface mode
Default
The default spanning tree state of the port is enabled.
Usage
Examples
Switch# configure terminal
Switch(config)# interface eth-0-1
Switch(config-if)# spanning-tree port enable
Related Commands
7.13 spanning-tree port-priority
Use this command to set the port priority for a bridge. A lower priority indicates a greater likelihood of the
bridge becoming root.
Command Syntax
spanning-tree port-priority priority
no spanning-tree priority
priority The priority to be assigned to the group.
Command Mode
Interface mode
Default