CANOGA PERKINS 9175 Command Reference - Manual (Page 179)

CanogaOS Command Reference
11-7
11.10 ethernet oam link-monitor remote-failure
Use this command to define action when remote failure is detected. Use no form of the
command to reset the action. .
Command Syntax
ethernet oam link-monitor remote-failure
critical-event|dying-gasp|link-fault action
error-disable-interface
no ethernet oam link-monitor remote-failure
critical-event|dying-gasp|link-fault action
error-disable-interface
Command Mode
Interface mode
Default
Remote failure does not trigger any interface events by default.
Examples
Switch# configure terminal
Switch(config)# interface eth-0-1
Switch(config-if)# ethernet oam remote-failure critical-event action
errordisable-interface
11.11 ethernet oam remote-loopback
Use this command to configure remote loopback on a interface. This command can be
used to enable or disable remote loopback and also configure the remote loopback timeout,
which is the number of seconds the DTE will wait for the remote DTE to respond to the
ethernet oam remote-loopback enable command. Use the no form of this command to
remove remote-loopback support from the interface.
Command syntax
ethernet oam remote-loopback supported | timeout SECS
no ethernet oam remote-loopback supported | timeout
supported Remote loopback can be initiated in the DTE
timeout Configure the timeout for remote loopback in seconds
SECS The remote loopback timeout value in the range of <1-10>