CANOGA PERKINS 9175 Command Reference - Manual (Page 286)

CanogaOS Command Reference
16-41
16.62 neighbor remote-as
Use this command to configure an internal or external BGP (iBGP or eBGP) TCP session with another router.
Command Syntax
neighbor NEIGHBORID remote-as ASNUM
NEIGHBORID = A.B.C.D|X:X::X:X|TAG
A.B.C.D Specifies the address of the BGP neighbor in IPv4 format.
X:X::X:X Specifies the address of the BGP neighbor in IPv6 format.
TAG Name of an existing peer-group. For information on how to create peer groups, refer to the
neighbor peer-group and neighbor remote-as commands. When this parameter is used with a command,
the command applies on all peers in the specified group.
ASNUM <1-65535> Neighbor’s autonomous system number
Command Mode
Router mode
Usage
This command is used to configure iBGP and eBGP sessions with other neighbors. A peer-group support of
this command is configured only after creating a specific peer-group.
Example
Switch# configure terminal
Switch(config)# router bgp 11
Switch(config-router)# neighbor 10.10.0.73 remote-as 345
16.63 neighbor remove-private-AS
Use this command to remove the private Autonomous System (AS) number from outbound updates.
Use the no parameter with this command too revert to default.
Command Syntax
(no)neighbor NEIGHBORID remove-private-AS
NEIGHBORID = A.B.C.D|X:X::X:X|TAG
A.B.C.D Specifies the address of the BGP neighbor in IPv4 format.
X:X::X:X Specifies the address of the BGP neighbor in IPv6 format.
TAG Name of an existing peer-group. For information on how to create peer groups, refer to the
neighbor peer-group and neighbor remote-as commands. When this parameter is used with a command,
the command applies on all peers in the specified group.
Default
Disabled