CANOGA PERKINS 9175 Command Reference - Manual (Page 704)

CanogaOS Command Reference
40-33
40.45 show network services
To display the network services in your switch, use the show network services command in privileged
EXEC mode.
Command Syntax
show network services {all | ipv4 | ipv6} {all | raw | tcp | udp} [numeric]
all Display IPv4 and IPv6 network services.
ipv4 Display IPv4 network services.
ipv6 Display IPv6 network services.
all Display RAW, TCP, and UDP information.
raw Display RAW information.
tcp Display TCP information.
udp Display UDP information.
numeric (Optional) Show numerical host addresses and port numbers.
Command Mode
Privileged EXEC
Usage
Examples
The following is sample output from the show network services command:
Switch# show network ser all all
Active Internet connections (only servers)
Proto Recv-Q Send-Q Local Address Foreign Address State
tcp 0 0 localhost:705 *:* LISTEN
tcp 0 0 localhost:smux *:* LISTEN
tcp 0 0 *:telnet *:* LISTEN
tcp 0 0 *:ssh *:* LISTEN
udp 0 0 *:router *:*
udp 0 0 *:snmp *:*
udp 0 0 *:3503 *:*
udp 0 0 *:bootps *:*
udp 0 0 *:tftp *:*
udp 0 0 200.200.200.201:ntp *:*
udp 0 0 100.100.100.100:ntp *:*
udp 0 0 localhost:ntp *:*
udp 0 0 *:ntp *:*
udp 0 0 ::1:ntp *:*
udp 0 0 *:ntp *:*
raw 0 0 *:2 *:* 7