CANOGA PERKINS 9175 Command Reference - Manual (Page 605)

33-14
Related Commands
deny
deny udp
deny icmp
deny igmp
33.20 deny udp
Use this command to reject UDP packets matching the IP filter.
Command Syntax
[<1-2147483646>] deny udp { source source-mask | any | host source } [ src-port operator
port ]{destination destination-mask any | host destination} [ dst-port operator port ] [ ip-precedence
precedence | dscp dscp ] [ fragments ] [ routed-packet ] [ options ] [ time-range time-range-name ]
[ stats ]
src-port: source port <0-65535>
dst-port: destination port <0-65535>
operator ˖including eq (equal to), lt (less than), gt (greater than), neq (not equal to), range
port: the port should be in the range <0-65535>
reference to command deny for other parameters
Command Mode
IP ACL configuration
Usage
The fragments will be invalid when the layer 4 information is specified (i.e. src-port).
Examples
This example shows how to create a filter in IP ACL to deny any UDP packets.
Switch(config-ip-acl)# 1 deny udp any any
This example shows how to create a filter in IP ACL to deny the UDP packets with the source IP 1.1.1.1,
source port 10, and destination port less than 2000.
Switch(config-ip-acl)# 2 deny udp host 1.1.1.1 src-port eq 10 any dst-port lt 2000
Related Commands
deny
deny tcp
deny icmp
deny igmp
CanogaOS Command Reference