CANOGA PERKINS 9175 Command Reference - Manual (Page 153)

CanogaOS Command Reference
9-5
no switchport dot1q-tunnel vlan mapping table
Command Mode
Interface configuration
Usage
Apply exist vlan mapping table on dot1q-tunnel port. The type of dot1q-tunnel port should be selective.
Examples
Switch (config-if)# switchport dot1q-tunnel vlan mapping table mp
Related Commands
show vlan mapping table
9.9 switchport trunk vlan-translation
Use this command to enable vlan translation on trunk port.
Command Syntax
switchport trunk vlan-translation
no switchport trunk vlan-translation
Command Mode
Interface configuration
Usage
Enable vlan translation on trunk port. Vlan translation can only be enabled on trunk port.
Examples
Switch (config-if)# switchport trunk vlan-translation
Related Commands
show interface switchport
9.10 switchport trunk vlan-translation mapping table
Use this command to apply vlan mapping table on vlan translation enabled port.
Command Syntax
switchport trunk vlan-translation vlan mapping table WORD
no switchport trunk vlan-translation vlan mapping table
Command Mode
Interface configuration
Usage
Apply exist vlan mapping table on vlan translation port. The vlan mapping entry should be without evc.