CANOGA PERKINS 9175 Command Reference - Manual (Page 743)

CanogaOS Command Reference
42-2
Command Mode
Global configuration
Usage
Examples
The following is sample output from the dhcp-server command:
Switch(config)# dhcp-server 1 1.1.1.1 2.2.2.2 3.3.3.3
Related Commands
service dhcp
dhcp-server (interface)
42.3 dhcp-server (interface)
To add an interface into a DHCP server group, use the dhcp-server command in interface configuration
mode. To remove this interface from the DHCP server group, use the no form of this command.
Command Syntax
dhcp-server number
no dhcp-server
number Number of the DHCP server group. The range is from 1 to 16.
Default
No DHCP server group is added.
Command Mode
Interface configuration
Usage
Examples
The following is sample output from the dhcp-server command:
Switch(config)# interface eth-0-1
Switch(config-if)# dhcp-server 1
Related Commands
service dhcp
dhcp-server (global)