CANOGA PERKINS 9175 Command Reference - Manual (Page 178)

CanogaOS Command Reference
11-6
WINDOW Window for frame-seconds events, in milliseconds, in multiples of 100, in
the range <100-900>.
Command Mode
Interface mode
Default
The default value for high threshold is none, meaning that no high threshold is configure.
The default value for the low threshold is 1. The default value of frame event window is
1000.
Examples
Switch# configure terminal
Switch (config)# interface eth-0-1
Switch (config-if)# ethernet oam link-monitor frame-seconds threshold high 5 low 2 window 200
11.9 ethernet oam link-monitor high threshold action
Use this command to define action when high threshold is detected. Use no form of the
command to reset the action.
Command Syntax
ethernet oam link-monitor high threshold action error-disable-interface
no ethernet oam link-monitor high threshold action error-disable-interface
error-disable-interface Disable the interface when high threshold is exceeded.
Command Mode
Interface mode
Default
When high threshold is exceeded it will generate only the corresponding link event and will
not trigger any interface events by default
Examples
Switch# configure terminal
Switch (config)# interface eth-0-1
Switch (config-if)# ethernet oam link-monitor high threshold action
error-disableinterface