CANOGA PERKINS 9175 Command Reference - Manual (Page 150)

CanogaOS Command Reference
9-2
Usage
This example shows how to add one vlan mapping entry to vlan mapping table
Examples
Add vlan mapping entry, raw vlan is from 10 to 20, mapped vlan is 100:
Switch (config)# vlan mapping table map_table
Switch (config-vlan-mapping)# raw-vlan 10-20 mapped-vlan 100
Related Commands
show vlan mapping table WORD
9.3 show vlan mapping table
Use this command vlan mapping table.
Command Syntax
show vlan mapping table [WORD {applied-interface | mapped-vlan vlan |raw-vlan {vlan |
out-of-range | untagged }} | applied-interface ]
WORD: the vlan mapping table to be displayed
applied-interface: display interface who use the vlan mapping table
mapped-vlan: mapped VLAN corresponding to the Raw-VLAN
raw-vlan: raw VLAN
out-of-range: null VLAN
untagged: the out of range raw VLANs
Command Mode
Privileged EXEC
Usage
This example show all vlan mapping table existed in system
Examples
Switch # show vlan mapping table
Related Commands
show vlan mapping table WORD
9.4 switchport mode
Use this command to configure switchport mode
Command Syntax
switchport mode {access|trunk|dot1q-tunnel}
no switchport dot1q-tunnel
dot1q-tunnel: configure this port to dot1q-tunnel port.