CANOGA PERKINS 9175 Command Reference - Manual (Page 201)

CanogaOS Command Reference
14-8
ip rip split-horizen [poisoned]
no ip rip split-horizen
poisoned Split horizon with poisoned reverse.
Default
This command is enabled with poisoned reverse by default.
Command Mode
Interface configuration
Usage
In general, changing the state of the default for the ip rip split-horizon command is not recommended,
unless you are certain that your application requires a change in order to properly advertise routes.
Examples
The following example enables split horizon without poisoned reverse:
Switch(config-if)# ip rip split-horizen
Related Commands
14.11 network (RIP)
To specify a list of networks for the Routing Information Protocol (RIP) routing process, use the network
command in router configuration mode. To remove an entry, use the no form of this command.
Command Syntax
network {prefix/prefix-length | interface-id}
no network {prefix/prefix-length | interface-id}
prefix IP route prefix for the network.
prefix-length Prefix length for the network.
interface-id The interface name for the network.
Default
No networks are specified.
Command Mode
Router configuration
Usage
There is no limit to the number of network commands you can use on the switch. RIP routing updates
will be sent and received only through interfaces on this network.
RIP sends updates to the interfaces in the specified networks. Also, if the network of an interface is not
specified, the interface will not be advertised in any RIP update.