CANOGA PERKINS 9175 Command Reference - Manual (Page 197)

CanogaOS Command Reference
14-4
Default
No authentication is provided for RIP packets.
Command Mode
Interface configuration
Usage
If neither key chain is configured with the key-chain command nor string is configured with the
authentication string command, no authentication is performed on the interface (not even the default
authentication). Key chain and authentication string can not be configured on the same interface. If you
want configure one, make sure the other is not configured.
Examples
The following example configures the interface to accept and send any key belonging to the key chain
named trees:
Switch(config-if)# ip rip authentication key-chain trees
Related Commands
ip rip authentication mode
14.5 ip rip authentication mode
To specify the type of authentication used in Routing Information Protocol (RIP) Version 2 packets, use
the ip rip authentication mode command in interface configuration mode. To restore clear text
authentication, use the no form of this command.
Command Syntax
ip rip authentication mode {text | md5}
no ip rip authentication mode
text Clear text authentication.
md5 Keyed Message Digest 5 (MD5) authentication.
Default
Clear text authentication is provided for RIP packets.
Command Mode
Interface configuration
Usage
RIP Version 1 does not support authentication.
Examples
The following example configures the interface to use MD5 authentication: