CANOGA PERKINS 9175 Command Reference - Manual (Page 287)

CanogaOS Command Reference
16-42
Command Mode
Router mode and Address Family (ipv4 unicast | ipv4 multicast | ipv6 | vpnv4 unicast) mode
Usage
The private AS numbers range from <64512-65535>. Private AS numbers are not advertised to the Internet.
This command is used with external BGP peers only. The router removes the AS numbers only if the update
includes private AS numbers. If the update includes both private and public AS numbers, the system treats it
as an error.
Example
Switch# configure terminal
Switch(config)# router bgp 10
Switch(config-router)# neighbor 10.10.0.63 remove-private-AS
16.64 neighbor route-reflector-client
Use this command to configure the router as a BGP route reflector and configure the specified neighbor as its
client.
Use the no parameter with this command to indicate that the neighbor is not a client.
Command Syntax
(no) neighbor NEIGHBORID route-reflector-client
NEIGHBORID = A.B.C.D|X:X::X:X|TAG
A.B.C.D Specifies the address of the BGP neighbor in IPv4 format.
X:X::X:X Specifies the address of the BGP neighbor in IPv6 format.
TAG Name of an existing peer-group. For information on how to create peer groups, refer to the
neighbor peer-group and neighbor remote-as commands. When this parameter is used
with a command, the command applies on all peers in the specified group.
Command Mode
Router mode and Address Family mode
Usage
Route reflectors are a solution for the explosion of iBGP peering within an autonomous system. By route
reflection the number of iBGP peers within an AS is reduced. Use the neighbor route-reflector-client
command to configure the local router as the route reflector and specify neighbors as its client.
An AS can have more than one route reflector. One route reflector treats the other route reflector as another
iBGP speaker.
Examples
Switch# configure terminal
Switch(config)# router bgp 10
Switch(config-router)# neighbor 10.10.0.72 route-reflector-client