CANOGA PERKINS 9175 Command Reference - Manual (Page 616)

CanogaOS Command Reference
34-1
34 ARP Inspection Commands
34.1 arp access-list
To define an ARP access list or add clauses at the end of a predefined list, use the arp access-list
command in global configuration mode. To remove an ARP access list, use the no form of this
command.
Command Syntax
arp access-list name
no arp access-list name
name Specifies the access control list name.
Default
No ARP ACLs are defined.
Command Mode
Global configuration
Usage
Examples
This example shows how to define an ARP access list named static-hosts:
Switch(config)# arp access-list static-hosts
Related Commands
ip arp inspection filter vlan
34.2 ip arp inspection filter vlan
To permit ARPs from hosts that are configured for static IP when DAI is enabled and to define an ARP
access list and apply it to a VLAN, use the ip arp inspection filter vlan command in global configuration
mode. To disable this application, use the no form of this command.
Command Syntax
ip arp inspection filter arp-acl-name vlan vlan-range [static]
no ip arp inspection filter arp-acl-name vlan vlan-range
arp-acl-name ARP access control list name.
vlan-range VLAN number or range; valid values are from 1 to 4094.
static (Optional) Specifies that the access control list should be applied statically.