CANOGA PERKINS 9175 Command Reference - Manual (Page 646)

CanogaOS Command Reference
37-9
If the RADIUS server is only a few hops from the router, we recommend that you configure the RADIUS
server retransmit rate to 5.
Examples
The following is sample output from the radius retransmit command:
Switch(config)# radius retransmit 5
Related Commands
radius-server host
radius-server key
37.12 radius timeout
To set the interval for which a router waits for a server host to reply, use the radius-server timeout
command in global configuration mode. To restore the default, use the no form of this command.
Command Syntax
radius-server timeout seconds
no radius-server timeout
seconds Number that specifies the timeout interval, in seconds. The range is 1 to 1000. The
default is 5 seconds.
Default
5 seconds
Command Mode
Global configuration
Usage
Use this command to set the number of seconds a router waits for a server host to reply before timing
out.
If the RADIUS server is only a few hops from the router, we recommend that you configure the RADIUS
server timeout to 15 seconds.
Examples
The following is sample output from the radius timeout command:
Switch(config)# radius retransmit 15
Related Commands
radius-server host
radius-server key