CANOGA PERKINS 9175 Command Reference - Manual (Page 438)

CanogaOS Command Reference
25-26
Defaults
The default is 45 seconds.
Examples
In the following example, the ldp targeted-peer-hold-time command is used
to set the time-out value that is the time that the router waits before rejecting
an adjacency with a targeted peer:
Switch# configure terminal
Switch(config)# interface eth0
Switch(config-if)# ldp targeted-peer-hold-time 635
Related Commands
show ldp interface IFNAME
targeted-peer-hold-time
25.30 router ldp
This command is used to enter the LDP specific command-line mode in which
global attributes for the LDP process can be set. Without this command, the
LSR does not perform any LDP operations, such as sending hello packets.
Command Syntax
router ldp
Syntax description
This command has no arguments or keywords.
Command Mode
Configure mode
De f aults
This command has no default settings.
Examples
In the following example, the router ldp command is used to enter the LDP
specific command-line mode in which global attributes for the LDP process can
be set: