CANOGA PERKINS 9175 Command Reference - Manual (Page 492)

CanogaOS Command Reference
28-4
apply policies to large numbers of routes by using match and set commands. Community lists
are used to identify and filter routes by their common attributes.
Use the match community command to allow matching based on community lists.
The values set by the match community command overrides the global values. The route that
does not match at least one match clause is ignored.
Note:
This command is valid only for BGP.
Command Syntax
match community WORD
no match community
Syntax Description
WORD Specifies the Community-list name.
Command Mode
Route-map mode
Defaults
No match community is specified by default.
Examples
Switch# configure terminal
Switch(config)# route-map myroute permit 3
Switch(config-route-map)# match community mylist
Related Commands
match ip address
match as-path
set as-path
set community
match metric
28.4 match interface
Use this command to define the interface match criterion.
Use the no parameter with this command to remove the specified match criterion.
.
The match interface command specifies the next-hop interface name of a route to be matched.