CANOGA PERKINS 9175 Command Reference - Manual (Page 490)

CanogaOS Command Reference
28-2
Examples
The following example shows how to create a route-map and enter route-map
configuration mode:
Switch(config)# route-map rip-to-ospf permit
Switch(config-route-map)# match metric 1
Switch(config-route-map)# set metric 2
Related Commands
match as-path
match community
match interface
match ip address
match local-preference
match metric
match origin
match route-type
match tag
set aggregator
set as-path
set atomic-aggregate
set comm-list
set community
set dampening
set extcommunity
set ip address
set local-preference
set metric
set metric-type
set origin
set originator-id
set tag
set vpnv4
set weight
28.2 match as-path
Use this command to match an autonomous system path access list.
Use the no parameter with this command to remove a path list entry.
The match as-path command specifies the autonomous system path to be matched. If there is a
match for the specified AS path, and permit is specified, the route is redistributed or controlled,
as specified by the set action. If the match criteria are met, and deny is specified, the route is
not redistributed or controlled. If the match criteria are not met then the route is neither