CANOGA PERKINS 9175 Command Reference - Manual (Page 282)

CanogaOS Command Reference
16-37
Switch(config-router)# neighbor 10.10.0.72 maximum-prefix 1244 warning-only
16.56 neighbor next-hop-self
Use this command to configure the router as the next hop for a BGP-speaking neighbor or peer group.
Use the no parameter with this command to disable this feature.
Command Syntax
(no) neighbor NEIGHBORID next-hop-self
NEIGHBORID = A.B.C.D|X:X::X:X|TAG
A.B.C.D Specifies the address of the BGP neighbor in IPv4 format.
X:X::X:X Specifies the address of the BGP neighbor in IPv6 format.
TAG Name of an existing peer-group. For information on how to create peer groups, refer to the
neighbor peer-group and neighbor remote-as commands. When this parameter is used with a command,
the command applies on all peers in the specified group.
Command Mode
Router mode and Address Family mode
Usage
This command allows a BGP router to change the nexthop information that is sent to the iBGP peer. The
nexthop information is set to the IP address of the interface used to communicate with the neighbor.
Examples
Switch# configure terminal
Switch(config)# router bgp 10
Switch(config-router)# neighbor 10.10.0.72 remote-as 100
Switch(config-router)# neighbor 10.10.0.72 next-hop-self
16.57 neighbor override-capability
Use this command to override a capability negotiation result.
Use the no parameter with this command to disable this function
Command Syntax
(no) neighbor NEIGHBORID override-capability
NEIGHBORID = A.B.C.D|X:X::X:X|TAG
A.B.C.D Specifies the address of the BGP neighbor in IPv4 format.
X:X::X:X Specifies the address of the BGP neighbor in IPv6 format.
TAG Name of an existing peer-group.
For information on how to create peer groups, refer to the neighbor peer-group and neighbor remote-as
commands. When this parameter is used with a command, the command applies on all peers in the