CANOGA PERKINS 9175 Command Reference - Manual (Page 463)

CanogaOS Command Reference
26-5
Command Syntax
mpls map-route { A.B.C.D/M | A.B.C.D M.M.M.M } N.N.N.N/M
Syntax Description
A.B.C.D/M IPv4 prefix to be mapped.
A.B.C.D
M.M.M.M IPv4 prefix to be mapped.
N.N.N.N/M FEC for route to be mapped to.
Command Mode
Configure mode
Defaults
This command has no default settings.
Examples
In the following example, the mpls map-route command is used to specify one
FEC mapped to a FTN entry:
Switch# configure terminal
Switch(config)# mpls map-route 100.100.100.0/24 200.200.200.0/24
Related Commands
no mpls map-route
26.8 no mpls map-route
Use this command to remove one route map relation.
Command Syntax
no mpls map-route {A.B.C.D/M | A.B.C.D M.M.M.M} N.N.N.N/M
Syntax Description
A.B.C.D/M IPv4 prefix to be mapped.
A.B.C.D
M.M.M.M IPv4 prefix to be mapped.
N.N.N.N/M FEC for route to be mapped to.
Command Mode
Configure mode
Defaults
This command has no default settings.
Examples