CANOGA PERKINS 9175 Command Reference - Manual (Page 202)

CanogaOS Command Reference
14-9
Examples
The following example defines RIP as the routing protocol to be used on all interfaces connected to
networks 10.99.0.0/16 and 192.168.7.0/24:
router rip
network 10.99.0.0/16
network 192.168.7.0/24
!
Related Commands
router rip
14.12 neighbor (RIP)
To define a neighboring switch with which to exchange routing information, use the neighbor command
in router configuration mode. To remove an entry, use the no form of this command.
Command Syntax
neighbor ip-address
no neighbor ip-address
ip-address IP address of a peer switch with which routing information will be exchanged.
Default
No neighboring switches are defined.
Command Mode
Router configuration
Usage
This command permits the point-to-point (nonbroadcast) exchange of routing information. When it is
used in combination with the passive-interface router configuration command, routing information can
be exchanged between a subset of switches and access servers on a LAN.
Multiple neighbor commands can be used to specify additional neighbors or peers.
Examples
In the following example, RIP updates are sent to all interfaces on network 10.108.0.0 except eth-0-1.
However, in this case a neighbor switch configuration command is included. This command permits the
sending of routing updates to specific neighbors. One copy of the routing update is generated per
neighbor.
router rip
network 10.108.0.0/16
passive-interface eth-0-1
neighbor 10.108.20.4
!