CANOGA PERKINS 9175 Command Reference - Manual (Page 144)

CanogaOS Command Reference
8-8
Switch#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)#interface eth-0-9
Switch(config-if)#switchport mode trunk
Switch(config-if)#switchport trunk allowed vlan add 15
Switch(config-if)#exit
Switch(config)#erps 11 ring 1 edge interface eth-0-9
And you can check the result by using “show erps 11” command.
Switch# show erps 11
ERPS domain ID: 11
ERPS domain name: test11
ERPS domain primary control VLAN ID: 16
ERPS domain sub control VLAN ID: 15
ERPS domain hello timer interval: 1 second(s)
ERPS domain fail timer interval: 5 second(s)
ERPS ring ID: 1
ERPS ring level: sub
ERPS ring 1 node mode: transit
ERPS ring 1 edge node mode: edge
ERPS ring 1 node state: idle
ERPS ring 1 edge interface name: eth-0-9
ERPS ring 1 common interface name: not configured
EPRS ring 1 SRPT is enabled
Related Commands
None
8.9 erps ring srpt
Use this command to enable/disable srpt functionality for specific ERPS ring instance.
Command Syntax
erps ERPS_ID ring RING_ID srpt {enable|disable}
ERPS_ID : <1-255> ERPS domain ID
RING_ID : <1-255> ERPS ring ID
enable: enable the srpt
disable: disable the srpt
Command Mode
Global configuration
Usage
This command is only available for edge node.