CANOGA PERKINS 9175 Command Reference - Manual (Page 194)

CanogaOS Command Reference
14-1
14 RIP Commands
14.1 default-information originate (RIP)
To generate a default route into Routing Information Protocol (RIP), use the Default -information
originate command in router configuration mode. To disable this feature, use the no form of this
command.
Command Syntax
default-information originate
no default-information originate
Default
This command is disabled by default.
Command Mode
Router configuration
Usage
Examples
The following example originates a default route (0.0.0.0/0) over a certain interface when
192.168.0.0/24 is present.
router rip
version 2
network 192.168.16.0/24
default-information originate
!
Related Commands
14.2 default-metric (RIP)
To set default metric values for Routing Information Protocol (RIP), use the Default -metric command
in router configuration mode. To return to the default state, use the no form of this command.
Command Syntax
default-metric number-value
no default-metric
number-value Default metric value. The number range is 1 to 16.