CANOGA PERKINS 9175 Command Reference - Manual (Page 403)

CanogaOS Command Reference
24-8
The source address for pim register is the interface ip of dr by default.
Examples
This example shows how to set the source address for pim register to the ip address of interface eth-0-1.
Switch(config)#ip pim register-source eth-0-1
This example shows how to return the source address for pim register to default value.
Switch(config)#no ip pim register-source
Related Commands
ip pim register-rate-limit
ip pim register-rp-reachability
ip pim register-suppression
24.13 ip pim register-rp-reachability
Use this command to enable rp reachability check for pim registers.
To disable this check, use the no form of this command.
Command Syntax
ip pim register-rp-reachability
no ip pim register-rp-reachability
Command Mode
Global configuration
Usage
None
Examples
This example shows how to enable rp reachability check for pim registers.
Switch(config)#ip pim register-rp-reachability
This example shows how to disable rp reachability check for pim registers.
Switch(config)#no ip pim register-rp-reachability
Related Commands
ip pim register-rate-limit
ip pim register-source
ip pim register-suppression
24.14 ip pim register-suppression
Use this command to set the register suppression time.
To return this time to default value, use the no form of this command.