CANOGA PERKINS 9175 Command Reference - Manual (Page 112)

CanogaOS Command Reference
7-9
The default priority is 1.
Usage
Examples
Switch# configure terminal
Switch(config)# interface eth-0-1
Switch(config-if)# spanning-tree port-priority 240
Related Commands
7.14 spanning-tree pathcost-standard
Use this command to set the path cost standard associated with the default bridge-group. Use the no
parameter with this command to set to default value.
Command Syntax
spanning-tree pathcost-standard {dot1d-1998 | dot1t}
no spanning-tree pathcost-standard
dot1d-1998 IEEE 802.1D-1998 standard.
dot1t IEEE 802.1T standard.
Command Mode
Global configuration
Default
The default pathcost-standard is dot1t
Usage
Examples
Switch# configure terminal
Switch(config)# spanning-tree pathcost-standard dot1d-1998
Related Commands
7.15 spanning-tree path-cost
Use this command to set the cost of a path associated with the default bridge-group. The lower the path
cost, the greater the likelihood of the bridge becoming root. Use the no parameter with this command to
calculate path cost according to interface’s speed.