CANOGA PERKINS 9175 Command Reference - Manual (Page 715)

CanogaOS Command Reference
40-44
traceroute command in privileged EXEC mode.
Command Syntax
traceroute [ip-address | ip ip-address | ipv6 ipv6-address | vrf name ip-address]
ip-address The target IP address.
ipv6-address The target IPv6 address.
vrf name For a specific VRF instance.
Command Mode
Privileged EXEC
Usage
When not specified, the protocol argument is determined by the software examining the format of the
destination argument. For example, if the software finds a destination argument in IP format, the protocol
value defaults to IP.
Examples
The following example is sample dialog from the traceroute command using default values.
Switch# traceroute 192.168.0.1
Related Commands
ping
40.59 boot system
To specify the system image that the switch loads at startup, use one of the following boot system
commands in privileged EXEC mode.
Command Syntax
boot system file-name
file-name The file name that will be used to load at starup.
Command Mode
Privileged EXEC
Usage
Examples
The following example is sample dialog from the boot system command.
Switch# boot system flash:/boot/ Internal-1.0.0.25.img
Related Commands
show boot