CANOGA PERKINS 9175 Command Reference - Manual (Page 334)

CanogaOS Command Reference
19-3
not redistributed or controlled. If the match criteria are not met then the route is neither
accepted nor forwarded, irrespective of permit or deny specifications.
The route specified by the policies might not be the same as specified by the routing protocols.
Setting policies enable packets to take different routes, depending on their length or content.
Packet forwarding based on configured policies overrides packet forwarding specified in routing
tables.
Note:
This command is valid only for BGP.
Command Syntax
match as-path LISTNAME
no match as-path
Syntax Description
LISTNAME Specifies as autonomous system path access list
name.
Command Mode
Route-map mode
Defaults
No match as-path is specified by default.
Examples
Switch# configure terminal
Switch(config)# route-map myroute deny 34
Switch(config-route-map)# match as-path myaccesslist
Related Commands
match metric
match ip address
match community
set as-path
set community
19.3 match community
Use this command to specify the community to be matched.
Use the no parameter with this command to remove the community list entry.