CANOGA PERKINS 9175 Command Reference - Manual (Page 643)

CanogaOS Command Reference
37-6
packets by the switch to the IEEE 802.1x client. The range is 1 to
65535.
tx-period seconds Number of seconds that the switch waits for a response to an
EAP-request/identity frame from the client before retransmitting
the request. The range is 1 to 65535.
Default
These are the default settings:
reauth-period is 3600 seconds.
tx-period is 30 seconds.
supp-timeout is 30 seconds.
server-timeout is 30 seconds.
Command Mode
Interface configuration
Usage
You should change the default value of this command only to adjust for unusual circumstances such as
unreliable links or specific behavioral problems with certain clients and authentication servers.
The dot1x timeout reauth-period interface configuration command affects the behavior of the switch
only if you have enabled periodic re-authentication by using the dot1x reauthentication interface
configuration command.
Examples
The following is sample output from the dot1x timeout command:
Switch(config-if)# dot1x reauthentication
Switch(config-if)# dot1x timeout reauth-period 4000
Related Commands
show dot1x
37.9 radius deadtime
To improve RADIUS response times when some servers might be unavailable and cause the
unavailable servers to be skipped immediately, use the radius-server deadtime command in global
configuration mode. To set dead-time to default value, use the no form of this command.
Command Syntax
radius-server deadtime minutes
no radius-server deadtime
minutes Length of time, in minutes, for which a RADIUS server is skipped over by transaction
requests, the range is 1 to 20.
Default